Dell Wyse WES7 conversion kit for Z class Installationsanleitung

Installation GuideWyse® Z Class Conversion to WES7Wyse® USB Firmware ToolTM Release 1.16Products: Z50, Z90DW, Z90SWIssue: 051112PN: 883887-31L Rev. A

6 Chapter 29. (a) Align the cover screw tabs with screw holes and press downward; (b) slide cover toward the front of the thin client, as shown in Fig

3 Installing WES7 FirmwareThis chapter includes the requirements and procedures you need to install and use Wyse® USB Firmware ToolTM to update your t

8 Chapter 3ProceduresIMPORTANT: Complete the following procedures as an administrator (administrator privileges are required).Step 1: Copy the Z90D_S

Installing WES7 Firmware 92. Click Next to open the Select an Option dialog box.Figure 8 Configuration options3. Select the Configure the USB key to C

10 Chapter 3Figure 10 Browse for image file8. Click Browse.Figure 11 Browse to select commandsXml.xml 9. Navigate to the Z90D_S 4GB_8GB WES7 Conversio

Installing WES7 Firmware 11Figure 12 Prepare USB drive 11.Select the USB key onto which you want the configurations (you can use Refresh as needed to

12 Chapter 3TipYou can use the configured USB key to push the firmware onto as many target devices as you want (repeat "Step 4: Use the Configure

Installing WES7 Firmware 13Figure 13 Placement of Wyse Conversion Label (blank example) Figure 14 Placement of Microsoft License Label (blank example)

14 Chapter 3TroubleshootingThis section contains general troubleshooting information.USB Keys - Troubleshooting Boot IssuesDue to different manufactur

Installing WES7 Firmware 15This page intentionally blank.

Copyright Notices© 2012, Wyse Technology Inc. All rights reserved.This manual and the software and firmware described in it are copyrighted. You may n

Installation GuideWyse® Z Class Conversion to WES7Issue: 051112Written and published by: Wyse Technology Inc., May 2012Created using FrameMaker® and A

Contents1 Introduction 1Kit Contents 1Kit Warranty 2Overview 2Wyse Technical Support 2Related Documentation and Services 2Wyse Online Community 22 Ins

iv ContentsThis page intentionally blank.

1 IntroductionThis guide provides step-by-step instructions to use Wyse® USB Firmware Tool to convert the following Wyse Z class thin clients to WES7:

2 Chapter 1The Conversion Software Assembly DVD-ROM contains:• A PDF of this Reference Guide• Wyse USB Firmware Tool Release 1.16 • Z90D_S 4GB_8GB WES

2 Installing Z Class FlashThis chapter contains information for users of Wyse Z class thin clients who must install new flash. If you are installing f

4 Chapter 2Figure 2 Removing the cover screws4. Place your thumbs on the top surface above where the end screws were removed. With a continuous motion

Installing Z Class Flash 5Figure 4 Removing the cover 6. Remove the cover to expose the flash module, as shown in Figure 5. WarningFlash modules may b